Jeep TrackHawk Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
I just ordered LED tail lights for my Jeep (made by Novsight, not something super sketchy).

I used to have LED turn signals up front (before I realized they looked awful. I remember that the LED turn signal unit made them blink at a decent speed, but the turn signal arrows on my Jeep's instrument cluster were always dimly illuminated which is what happens when it thinks your running lights are out.

I was wondering if there's a way to use the new tail light units without load resisters and have both the blink rate and the cluster indicators normal?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.