Installing Headers

1514 Views 5 Replies 4 Participants Last post by coanan, 10 mo ago

Philth

Discussion Starter · 10 mo ago

I was watching a video on YouTube on a Hemi rebuild. The guy took the head off with the header still attached. Seeing how little room there is on the TH, has anybody done this before? Seems like achieving actual fastener torque would be ideal with the head off. Not even sure a long tube would fit doing this method though. Anybody?

Save

1 - 6 of 6 Posts

Vanquishglory

· #2 · 10 mo ago

There is a youtube video of a trackhawk being built for a giveaway. They swapped the headers without removing the heads.

Save

coanan

· #3 · 10 mo ago

I did it with eng in and heads on minimal stuff removed. Write up somewhere on here.

Save

mtcs

· #4 · 10 mo ago

I did mine a few weeks ago. Left the heads on.

Save

Reactions: 1

Philth

Discussion Starter · #5 · 10 mo ago

mtcs said:
I did mine a few weeks ago. Left the heads on.

Did you take any engine mounts out?

Save

coanan

· #6 · 10 mo ago

Mods begin

Put the 300 tuning aside, running out of time for trip, taking Trackhawk, so the mods started. Loaded ECU/TCM tune New pads and rotors up front. I'd say the catch can did it's job. Jeezes the amount of sensors to unplug Valves look nice and clean half day tomorrow. SC pulley on...

www.jeeptrackhawk.org

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Mods begin

Top Contributors this Month